In-Duct Adiabatic Humidification

Condair ME evaporative humidifier & cooler

The Condair ME provides low energy humidity control and evaporative cooling to an air handling unit or duct.

A single unit can provide up to 1,200kg/hr of humidification and 822kW of evaporative cooling to an air stream while operating on less than 1kW of electricity. As well as being economic to run the Condair ME is also easy to operate with an advanced touch screen control panel, simple to maintain with industry leading service features and employs the latest in hygiene technology.

The self-contained hydraulic unit supplies water to the top of the evaporative module, located either inside or outside the duct. Exterior mounting enables most servicing to be carried out without having to shut down and enter the air handling unit.

The Condair ME incorporates up to seven low energy 32W pumps rather than single large pump. This allows proportional energy consumption to system output and provides up to seven-stage control as standard.

Evaporative humidifiers provide instant humidification in the AHU so they can be situated in short section lengths without the risk of wetting on bends. As minerals left behind after evaporation are regularly sent to drain, service requirements are considerably less than steam humidification.

Features and benefits

Very low energy consumption

Up to seven-stage control as standard

Instant evaporation requiring very short section length

Advanced touch screen control panel

Condair DL hybrid spray & evaporative humidifier

The Condair DL combines spray and evaporative technologies to provide close control, hygienic in-duct adiabatic humidification with low operating costs.

A grid of nozzles releases a fine spray into the air stream towards a ceramic droplet evaporator. What moisture isn’t immediately absorbed by the air precipitates onto this ceramic evaporator. As air flows through its porous surface, more water is absorbed by the air for highly efficient water use and droplet-free humidification.

This efficiency enables the humidifier to provide very close control at up to +/-2%RH, which is a level of control usually only achievable with steam humidification.

Hygienic operation of the humidifier is assured with use of pure reverse osmosis water, flush and drain cycles, a patented “Hygiene Plus” silver ionisation concept, optional H2O2 disinfection and compressed air drying of the water lines

Features and benefits

Initial stage control followed by fully modulating output provides very accurate humidity of up to +/-2%RH

Low energy humidification with the additional benefit of evaporative cooling

Multiple anti-microbial features for extremely hygienic operation